Coal Hybrid Power Plant (PP)

Forestry Coal Hybrid Thermal Energy Storage Power Plant (PP)

Works by magic. Does not need the incinerator to be a working power plant. Dual High Pressure Thermal Storage and supporting solar energy system. Four solid fuel boilers and two electric boilers for Thermal Storage charging. Excess low pressure steam is routed to thermal desalination. Pause pipe and boilers not required. Electric are in surplus mode. For advanced players and not beginners. The low pressure storage maybe cut from the blue print as an option.

Pipe squigglies are for timings to slow steam progress to reduce steam floods as its a trick to extend the pipe length over shorter distances. High pressure steam storage is regulated from cooling towers on steam loop return. One cooling tower a turbine to delay water delivery for water return loop to have time to unjam or unflood and process between storages. For low pressure turbines disable auto-balance when low pressure storage is charged or based on needs keep auto-on to promote extra water. Turbine train and shaft is maxed out at 72. Low pressure steam for scrubber sunk into low pressure steam storage decoupled from main low pressure line converging with a connector. Makes a bit of excess water when fully running. Power plant is ramp. Do not upgrade the tear I turbines on the high pressure thermal storage or main high pressure turbine train. As the system would unbalance.

Upgradeable with extra thermal storages piped into main line replacing coal boilers. If coal boilers removed for thermal storages and electric boilers for a solar power to heat system. Remove the scrubber or find another form of exhaust. Removing the solid fuel boilers for reactor optional. As Peaker boilers boilers off set lots to thermal storage but could back up the reactor. But you could keep a red line reactor stable so long as there is 386 water delivered for cooling and steam could exit the reactor to go somewhere.

Optional configuration for boilers. All tear II HPI turbines with auto-balance off. All tear I HP turbines auto-balance on. For turbines connected to thermal storage. This is the math for the thermal storages solid fuel fired boiler 48/1.1=43.63636363636364 + "Peaker" Electric boiler in surplus 12/1.1= 10.90909090909091 = 54.54545454545455 - 48 tear II turbine remainder 6.545454545454549 that is the tear I HP turbine every four revaluations of steam or it gets added to the tear II HP turbines next burst from the boiler.