Control to change belt routing does not work properly

Control to select an alternate belt path seems to work as a toggle but can't be turned off without clicking the button. So when i press control while doing a belt or pipe, i'm stuck with control pressed until i click the button again, which makes it inconvenient to use.

Same - I think it should reset after each clicked segment. In general, as I run transport, I will only click it down when I reach the maximum length or my pathing requirements change.

it should reset when you release control

Seeing the same thing. This used to work as a toggle as expected, though now it gets stuck in the alt mode. I use this function quite regularly, so I'm going to say this problem only started with 0.7.4 or fairly recently.

The activation sound when pressing control actually plays twice when trying to disable it, so the state may be changing from ON to OFF and back to ON from a single keyboard press with now way to "stop" at the OFF state again. As was pointed out already, manually clicking the button on the interface with the mouse is the only way to correct the issue.

Other usage of the alt route function with the CTRL key seems to be alright. It's only with transports.

The problem started in u3

the start of u3

I've also experienced this starting in update 3

Now fixed!