I have controller ("X") and Antenna II ("X"); this is my "output" set. Controller X has loose storage connected to STOCK module. Stock quantity is wired to A>B comparator input as A, with B value hard-coded at 400. C output is wired to AM-B input (and F-B display, which shows expected green/HI signal).

I have controller ("Y") and Antenna II ("Y"); this is my "input" set. Controller Y has AM-R output wired to S/signal module (and F-B display, which shows red/LO signal), which is to control whether or not a belt is paused.

The two sets are ~15 tiles from each other. Both controllers have antenna set to 610kHz. I've tried sending a simple HI/LO signal and, in a prior attempt, sending the quantity from STOCK module as input to AM-B, but neither work as I expect them to; I am not appearing to receive either on the AM-R module.

I do note when I press the "+" button in the "Redirected signals" pane of either antenna, I see no signals to redirect.

kldg wrote:

Original message

Hi kldg,

First important information:\

• AM is only for connection to world mines\
• FM is only for connection on the Island

For 20 tiles and lower distance is enough to be transferred by BUS configuration, see Announcements.

There is possible to use the Antena connected the controller:

The Antena needs to have selected correctly the FM, then you will also see the signals and strengths:

And if the antennas are more than 1000 tiles far from each other is possible to redirect the signal on the way.